1. Power LED - when lit indicates that the amplifier is on
2. Front Output Configuration Switch - determines the output
configuration of the amplifier
3. Front Gain Control - continuously adjusts from 200mV to 5Vrms
for full power output
4. 2-Channel / 4-Channel Switch - configures the amplifier for two or
four RCA inputs
5. Front RCA inputs - accepts RCA input from a source unit,
preamplifier or equalizer
6. Rear RCA outputs - accepts RCA input from a source unit, preampli-
fier or equalizer
7. Rear Crossover Control - adjusts the frequency for the rear channels
8. Rear Crossover Switch - configures the rear channel for high-pass,
low-pass or full range operation
9. Rear Output Configuration Switch - determines the output
configuration fo the amplifier
10. Front Crossover Switch - configures the front channel for high-
pass, low-pass or full range operation
11. Front Crossover Control - adjusts the frequency for the front
channels
12. Rear Gain Control - continuously adjusts from 200mV to 5Vrms
for full power output
TECHNICAL DESIGN FEATURES
13. REM Remote Turn-on Input - turns on the amplifier when
fed 12 V+
14. Speaker Connections - allow up to 12 gauge speaker wire
15. Fuse - protects the amplifier from over current situations
16. Power Connections - allow up to 4 gauge power and
ground cables
1
2
3
4
5
6789
10 11 12
13 15 1614
page 9
To Next Page
Loading...
