TECHNICAL DESIGN FEATURES
page 11
1. Power LED - lights up when the amplifier is on
2. Low-pass crossover frequency control-adjusts the front channel
low-pass crossover frequency
3. Low-pass crossover switch-activates the front channel low-pass
crossover
4. INTELLiQ gain-adjusts the level of INTELLiQ from 0dB to 10dB of
boost.
5. High-pass crossover “x10” switch-changes the high-pass crossover
frequency range
6. High-pass crossover frequency control-adjusts the front channel
high-pass crossover frequency
7. High-pass crossover switch-activates the front channel high-pass
crossover
8. Front Gain Control - continuously adjusts from 200mV to 5Vrms
for full power output
9. Front Output Configuration Switch - determines the output
configuration for the front channels
10. Front RCA Inputs- accepts RCA input from a source unit, preampli-
fier or equalizer for the front channels
11. Rear RCA Inputs- accepts RCA input from a source unit, preampli-
fier or equalizer for the rear channels
12. 2-Channel / 4-Channel Switch - configures the amplifier for two or
four RCA inputs
13. Rear Output Configuration Switch - determines the output
configuration for the rear channels
14. Rear Crossover Control - adjusts the frequency for the rear
channels
15. Rear channel input configures rear channels for direct input or
output of front channel crossover and gain
16. Rear Gain Control - continuously adjusts from 200mV to 5Vrms for
full power output
17. Rear Crossover Switch - configures the rear channel for high-
pass, low-pass or full range operation
18. REM Remote Turn-on Input - turns on the amplifier when fed 12
V+
19. Front speaker output- allows up to 12 gauge speaker wire
20. Rear speaker output- allows up to 12 gauge speaker wire
21. Remote Gain-allows dashboard control of the amplifier output
level
22. Fuse - protects the amplifier from over current situations
23. Power Connections - allow up to 4 gauge power and ground cables
1
2
6789
10
11 12
16
14
17
15
13543
18
19
20 21 2322
To Next Page
Loading...
