18
Area part arming
Zones can be grouped together to make ‘Area Sets’. Area Sets are often used in multi tenanted
houses where there is a communal entrance and separate living spaces. Users can arm
individual or multiple area sets. To part arm selected areas, please proceed as follows:
1. Enter your code or present tag to select the user menu.
2. From the user menu, use the U and D keys to scroll to ‘Area part arm 1’:
3. Use the L and R keys to change the part arm mode (1, 2 or 3), then press E or
k to select, the ‘part arm areas’ menu is now displayed:
` Area will be part armed
a Area will remain unarmed
4. Use the U and D keys to select the ‘Area’. Then use the L and R keys to toggle
the selected area on or off. Once you have selected the areas that you would like to part
arm, press E or k to confirm.
5. The exit tone will start and the keypad will instruct you to exit the protected area:
6. The keypad will then indicate that the areas that are part armed:
Part arm settings will be pre-programmed by your installation company.
To Next Page
Loading...
