Press the Return key, and enter the login credentials:
Note: The default login credentials are:
User name = spadmin
Password = admin123 (will not be displayed on the screen)
Note: For your reference, the command helpcli produces a list
of available commands. Press the space key to display the next
page, or the b key to display the previous page.
Note: Should it become necessary to leave the command help
mode (indicated by a command line prompt ":"), press Q, or
Ctrl C.
b.
If you are on a DHCP-enabled network, you can assign an IP address by
enabling DHCP on your unit . Use the dhcp4set <x> on command, (x
being 0/1 for ETH0 and ETH1, respectively).
16
VersaSync Getting Started Guide Rev. 8
2.1 Network Setup
To Next Page
Loading...