Page 14 Operation Manual - 2500
ENGLISH
Using a Thermostat
Using a thermostat will help maintain a constant temperature throughout the house. A Low voltage
thermostat (24 volts) is required. A fixed wall mount or hand held model can be used.
To use the stove in thermostat mode, press the «MODE» button until the «THERMOSTAT» position. is
reached. Then, select the intensity level using the «-» or «+» buttons. In thermostatic mode, the stove
will operate at the selected intensity level until the room temperature has reached the programmed
level on the thermostat.
Pilot Mode Selection
The factory setting of the pilot mode is «AUTO». To change it, press on the «-» and «MODE» buttons
simultaneously for 3 seconds. The selected mode will appear on the control panel display area.
Pilot AUTO (Intensity level 1)
When the thermostat stops calling for heat, the unit will remain at its lowest intensity level (#1) and will
shut down after 15 minutes, if there is no call for heat.
Pilot AUTO (Intensity level 2 to 6)
When the thermostat stops calling for heat, the unit automatically switch to its lowest intensity level
(#1) until the thermostat requires heat again. The stove will shut down after 45 minutes, if there is no
call for heat.
Pilot ON:
When the thermostat stops calling for heat, the unit automatically switch to its lowest intensity level
(#1) until the thermostat calls for heat again. The stove will never shut down, even if there is no call
for heat.
To avoid premature wear of the components, it is recommended to use the «Pilot ON» mode
during the coldest months and the «Pilot AUTO» mode during the warmest months.
Convection adjustments
Each intensity level has been programmed with an optimum convection speed. However, it is possible
to increase the convection air speed by pressing the «AUX» button. All intensity levels can be increased
at the exception of the intensity level 6, which is already at its maximum speed.
To Next Page
Loading...
Need help?
General