12
UNPACKING AND ASSEMBLY:
WARNING!
Failure to properly assemble and adjust your bike prior to use may result in an
accident resulting in death, serious injury and/or property damage. If you are
uncertain about any aspect of the assembly and adjustment of your bike, seek
help from a qualified mechanic or the OSET Customer Service Department.
WARNING!
There are no user serviceable elements incorporated into the motor, motor
controller, batteries, battery charger, throttle, or wiring harness of your OSET
electric bike. DO NOT ATTEMPT TO DISASSEMBLE OR ADJUST ANY OF
THESE COMPONENTS. Doing so may cause extensive damage to these
components, will void your warranty, and may cause a hazardous condition. If
you cannot resolve a problem using this owners manual, contact your OSET
authorized dealer, or call the OSET Customer Service Department for
assistance.
NOTE!
If you purchased your OSET at a local retailer your machine may be fully
adjusted and ready to ride. If you purchased your OSET in the carton, please
carefully follow the instructions below and any supplemental instructions to finish
the assembly and adjustment of your OSET.
OSET 20 inch
1. Remove your OSET & Accessory pack from the box and check contents
against the following list:
1/ Bike less front wheel
1/ Front wheel
1/ Accessory Box containing:
1/ Front mudguard (fender)
1/ Rear mudguard
1/ Battery charger c/w power lead & manual
1/ Battery bag
3/ Battery link wires
1/ Disc guard
1/ Disc guard clamp washer
1/ Number board
4/ Black cable ties
1/ Spring1000lb
2/ Front wheel spacer (these maybe all ready attached to front wheel
and secured with cable tie)
1/ Hex Key set (Allen keys)
1/ Manual for air forks
1/ Manual for rear shock
2. Place your OSET on a solid & level stand, with both wheels off the ground.
To Next Page
Loading...
