6
Charging the product battery
• Battery level indicator on the display
screen will flash to show that the
uCrown Smart is low in battery.
• Connect the uCrown Smart using the
supplied USB cable to a power source.
Double ‘beep’ sound can be heard once
it is connected.
• The battery level indicator bar will move
while it is charging. Once fully charged,
the battery level bar will be full.
• The uCrown Smart will not work while it
is charging.
• Each full charge (approximately 3.5-4
hours) lasts up to 160 minute of usage.
Turning the product on/off
• Press the [ ] button and it will emit
a ‘beep’ sound to indicate that the
uCrown Smart is turned on.
• Press and hold the [ ] button for
around 2 seconds until it emits a double
‘beep’ sound to indicate that the
uCrown Smart is turned off.
• The uCrown Smart will automatically
start ‘Mode 1’ program once it is turned
on.
Connecting uCrown Smart to the
music source
• Music Stream on product via BT from
smart device or any BT enabled music
player.
• Turn on the Bluetooth on your device.
Search for BT, OS1201 XXXXXXXX.
• Connect and wait for connection
confirmation.
• Start streaming.
• For ease of convenience, Bluetooth is
automatically connected to last paired
user.
Massage program selection
• Press the [ ] button anytime to cycle
through the 2 auto massage programs.
• Each auto massage program comes
with a different music track and during
the auto massage programs, the music
function can be turned on or off by
pressing the [ ] button.
i. Mode 1 (1 ‘beep’ sound and the
15 minute massage will begin).
ii. Mode 2 (1 ‘beep’ sound and the
15 minute massage will begin).
Operation
To Next Page
Loading...
