What to do if my OSIM uGalaxy Sync Massager won't start?
If your OSIM Massager isn't starting, there are a couple of things to check: * First, the battery level might be low. Recharge the battery fully before trying to use it again. * Second, the overcurrent protection device may have been activated. If this is the case, turn OFF the massager and let it cool down for at least 30 minutes before attempting to use it again.
Why does my OSIM Massager stop midway?
Your OSIM Massager might stop mid-session for a few reasons: * The auto timer, which is set to 15 minutes, may have lapsed. * The battery level could be low. Try recharging the battery before using the massager again. * The overcurrent protection device may have been activated. Turn OFF the product and allow it to cool down for at least 30 minutes before using it again.
What to do if my OSIM Massager USB cable are abnormally hot?
If the USB cable of your OSIM Massager gets abnormally hot, it could be due to the overcurrent protection device being activated. Turn OFF the product and allow it to cool down for at least 30 minutes before touching it again. If the problem continues, contact OSIM Service Center immediately.
How to fix unsuccessful Bluetooth pairing with OSIM Massager?
If you're having trouble pairing your OSIM Massager via Bluetooth, it might be due to signal interference. Try powering OFF the product, then power it back ON after 5 seconds, and try the pairing process again.
General| Model | uGalaxy Sync |
|---|---|
| Zero Gravity Positioning | Yes |
| Bluetooth Connectivity | Yes |
| Built-in Speakers | Yes |
| Auto Timer | Yes |
| Type | Massage Chair |
| Massage Techniques | Kneading, Tapping, Shiatsu |
| Adjustable Settings | Intensity |
| Body Scan Technology | Yes |
| Heat Therapy | Yes |
| User Profiles | Yes |
| Remote Control | Yes |
| Power Supply | 220-240V ~ 50/60Hz |
To Next Page
