4 Usage
4.1 Introduction
• At first, produce and dispense 5 litres of water which you then dispose of
by dispensing all the cold water. This will flush out any loose filter
media. It is normal to see black water when using new filters.
• If there is water leakage from the machine, please disconnect the power
and contact the customer service centre. If there is any abnormal or
unexpected sound, smell, or smoke, etc., please disconnect the power and
contact the customer service centre.
• If you live in a hard water area with over 280 ppm CaCO3 then we
recommend that you fill your supply tank with 3 litres of water not 5 litres.
4.2 Flushing
• After the setup, the machine automatically enters the flushing state and
works for 120 seconds. In the flushing state, the filtering symbol of the
display interface light will be on (see Figure 2) .
4.3 Purification
• After flushing, the machine automatically enters the filtering state. The
filtering symbol on the display interface light will be on (see Figure 2).
4.4 Replace Water
• The system will detect the source water quality in normal operation. If
the water level is lower than the set level, the user will be prompted to
replace the source water. You must empty the Supply Tank every time it
is refilled. The renew water symbol of the display interface will light up at
this time (see Figure 2).
IMPORTANT NOTE: You must empty the
Supply Tank before refilling it with fresh
water as failure to do this can block your
9
To Next Page
Loading...
