7.1 Preparing the system for shipment
1. Empty the supply tank
2. Remove the carbon, membrane and post filters
3. Turn off the machine at the switch, wait 5-10 seconds for all lights to go off
4. Turn the machine back on
5. Press the dispenser button for 3-5 seconds for a long press to begin
6. When the machine is empty, it will make a gurgling noise, if it does not do this
after the first long press, repeat steps 3-5.
7. Once the Osmio Zero’s internal tank is empty, lift the machine and turn it
upside down (over a sink) and then back upright around 5 times. Each time you
turn it upright, some water should leave the spout. Once no water leaves the
system it is ready to be packed and shipped.
8. Before re-installing the filters, turn them upside down and shake any water
from inside.
9. Re-install the filters and package the machine up, into its original box with
foam supports. If you no longer have the original packaging, please pack the
system in a resonable sized box and ensure there is enough stuffing and
packaging for the system to make it back to us safely. If unsure please contact
our customer service hotline on 0330 113 7181
7.2 Going on holiday
If you are going away for more than 3 - 4 days follow these instructions
1. Empty the supply tank
2. Remove the carbon, membrane and post filter
3. Turn off the machine at the switch, wait 5-10 seconds for all lights to go off
4. Turn the machine back on
5. Press the dispenser button for 3-5 seconds for a long press to begin
6. When the machine is empty, it will make a gurgling noise, if it does not do this
after the first long press, repeat steps 3-5.
7. Once the Osmio Zero’s internal tank is empty, lift the machine and turn it
upside down (over a sink) and then back upright around 5 times. Each time you
turn it upright, some water should leave the spout. Once no water leaves the
system it is ready to be packed and shipped.
8. Once no water leaves the system turn the filters upside down and shake any
water from inside and then re-install the filters on the system
9. On return from holiday fill the supply tank, allow the system to filter and fill the
internal tank, then dispense all water produced to flush the system. The
system is now ready to use again.
19
To Next Page
Loading...
