1270047_1
14
EN | Operation
12
13
15
14
12 Install possible peripheral equipment.
13 Make sure that the motor cable is not to close
to the fan wheel. The cable can be drawn further
into the junction box.
14 Refit the lid of the junction box.
15 Refit the lid on the fan
and tighten the screws.
6 Operation
WARNING!
The fan must be duct connected and the lid closed and locked before the fan is started in
order to avoid the risk of personal injury from rotating parts..
CAUTION!
To achieve maximum life time for installations in damp or cold environments, the fan
should be operating continuously.
For technical data please see the product label.
Before starting, make sure that:
• the current does not exceed more than +5% of what is stated on the label.
• the supplied voltage is within +6% to –10% of the rated voltage.
• no noise appears when starting the fan.
1270047_utg1_RS_sveng.indd 14 2020-12-21 16:03:25
EN_SE_Manual_RS_1270047u1.pdf 14EN_SE_Manual_RS_1270047u1.pdf 14 2020-12-21 16:11:082020-12-21 16:11:08
To Next Page
Loading...
Need help?
General
