OTC 5019A - Operating and Maintenance Instructions

Operating Instructions
1. Installthetransmissionadaptersonthetransmissionjackmountingplateusingthecarriagebolts,washers,
andangenutsprovided.Handtightentheangenuts.SeeFigure1.
2. Raisethearmofthejackuptothetransmission.
3. Adjustthetransmissionadaptersasneededtotthetransmission.Tightentheangenuts.
4. UseratchetstraptosecurethetransmissiontothetransmissionjackasshowninFigure2.Attachthe
hooksontheendoftheratchetstraptotheslotsprovidedinthemountingplate,thetopholesinthe
transmissionadapters,orothersuitablelocations.
Figure 1 Figure 2
Parts List & Operating Instructions Form No. 561957
Inspection and Maintenance
CAUTION: To prevent personal injury,
•
Only qualied personnel shall perform inspections and repairs to these transmission adapters.
•
Before each use, an approved inspector must inspect the transmission adapters for bends, cracks,
dents, elongated holes, or missing hardware. If damage is found, discontinue use.
•
Use only those repair parts called out in the parts list in this document. Items found in the parts
list have been carefully tested and selected by OTC.