Otto Bock 3R80 - Locking the Prosthetic Knee Joint; Cleaning

30
►
Inform the patient.
NOTICE
Mechanical overload
Impaired functionality due to mechanical damage
►
Check the product for damage prior to each use.
►
Do not use the product if its functionality has been impaired.
►
Take any necessary measures (e.g.repair, replacement, inspection by the manufacturer's
customer service, etc.).
INFORMATION
Leak in the product's hydraulic system
Environmental damage or skin irritation due to leaking hydraulic oil
►
Before each use, check the product for leaking hydraulic oil.
►
In case of leaks, do not continue using the product and have it repaired promptly.
6.1.1 Locking the Prosthetic Knee Joint
Locking the Prosthetic Knee Joint
1) Bring the prosthetic knee joint to full extension under load.
2) Push down the lock lever (see fig.21).
3) Check to verify that the prosthetic knee joint is locked.
Unlocking the Prosthetic Knee Joint
1) Bring the prosthetic knee joint to full extension under load.
2) Pull up the lock lever (see fig.22).
3) Check to verify that the prosthetic knee joint is unlocked.
6.2 Cleaning
CAUTION
Use of unsuitable cleaning agents or disinfectants
Impairment of functionality and damage due to incorrect cleaning agents or disinfectants
►
Only clean the product with the approved cleaning agents.
►
Only disinfect the product with the approved disinfectants.
►
Observe the instructions for cleaning and care.
INFORMATION
►
Clean the product after contact with liquids or if it gets dirty.
►
For disinfection, only use disinfectants that do not affect the materials of the product. For
further information, please consult the manufacturer.
►
Observe the cleaning instructions for all prosthetic components.
1) Clean the product with a damp cloth and soap.
2) Rinse the product with clean, fresh water.
3) Dry the product with a soft cloth.
4)
NOTICE! Do not store the product while moist.
Allow to air dry in order to remove residual moisture.