Otto Bock B-Series User Manual

R-Net wheelchair control
B-Series Ottobock | 89
Parameter Setting range Description
Lock Function
Enabled
None, se-
quence, key,
both
Used to set whether and how the R-Net control unit can be locked to prevent
the wheelchair from being used by unauthorised persons.
The programmable options are as follows:
• None: means that the R-Net cannot be locked
• Sequence: means that the R-Net can be locked/unlocked by pressing a
sequence of buttons
• Key: means that a key provided by the manufacturer can be used to lock/
unlock the R-Net.
• Both: means that either a sequence of buttons or a key can be used to
lock/unlock the R-Net.
Reverse Driving
Alarm
Yes, no Used to set whether an alarm signal sounds when the wheelchair is driving
in reverse
Emergency Stop
Switch
Yes, no Used to set whether an emergency stop switch must be used when operati-
on in latched mode is programmed.
When set to Yes, an emergency stop switch (break contact) must be con-
nected to the socket for the input device for the external profile on the joy-
stick module when latched driving or operation of the variable motor in latch
mode is programmed. If no emergency stop switch is installed, operation of
the wheelchair is blocked.
When set to No, no emergency stop switch is required. This setting should
only be used following an analysis of all the associated risks, i.e., no emer-
gency stop can be performed when driving or operating a variable motor in
latched mode.
Ottobock shall not be liable for any losses etc. of any kind resulting from
the use of a wheelchair which is programmed for driving or operation of a
variable motor in latched mode and which has not been installed with an
emergency stop switch.
Power-up Mode Last used,
drive, seat,
Bluetooth,
external de-
vices, mode5,
mode6, IR
mode, pro-
gramming
Used to set the mode which is selected when the system is switched on. If
Last used is selected, the mode which was selected when the wheelchair
was last switched off will be selected when it is next switched on.
If a mode is selected but the corresponding output module is not available,
the system automatically switches to driving mode when the wheelchair is
switched on.

Otto Bock B-Series Specifications

General

Brand	Otto Bock
Model	B-Series
Category	Wheelchair
Language	English