EasyManuals Logo

Otto Bock Kimba Spring Using Manual

Otto Bock Kimba Spring
Go to English
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
5 Product Specic Instructions - Rehab Buggy
– Lisa 2005 –
This rehab buggy features anchoring points. For this model, additional xation kits are not required.
This rehab buggy is equipped with back angle adjustment. Before starting check the backrest is
in almost upright position . Observe the specications in the Instructions for Use Manual of the
Rehab Buggy.
Pass one end of the pelvic belt through the rear corner of the seat/backrest upholstery. Now clip the pelvic belt
buckle onto the "Anchor Pin", then repeat on the opposite side for the other half of the pelvic belt.
Lisa Buggy showing the correct positioning of the tie-down straps.
Guidance for tting the Pelvic Belt

Table of Contents

Other manuals for Otto Bock Kimba Spring

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Otto Bock Kimba Spring and is the answer not in the manual?

Otto Bock Kimba Spring Specifications

General IconGeneral
BrandOtto Bock
ModelKimba Spring
CategoryStroller
LanguageEnglish

Related product manuals