19
Installation
Selecting a Location
This barbecue is for outdoor use only and
should be placed in a well-ventilated area, and
on a safe and even surface. Never place your
barbecue below ground level. Take care to
ensure that it is not placed UNDER any
combustible surface. The sides of the barbecue
should NEVER be closer than 1 metre from any
combustible surface, including trees and fences
and make sure that there are no heat sources
near the barbecue (cigarettes, open flames,
spark etc.). Keep this barbecue away from any
flammable materials!
Precautions
Do not obstruct any ventilation openings in the
barbecue body.
Position the gas bottle on level ground next to
the barbecue and safely away from any source
of heat.
Should you need to install or change the gas
bottle, confirm that the barbecue is switched off,
and that there are no sources of ignition
(cigarettes, open flame, sparks, etc.) near
before proceeding.
Connecting a Gas Hose to the Barbecue
Connect the gas hose to the gas rail inlet on the
left hand side of the barbecue. Do not
overtighten. Do not use any sealing tape, paste
or liquid on the connection.
Fixing a Regulator to the Gas Bottle
Confirm all barbecue control knobs are in the off
position. Connect the regulator to the gas bottle
according to your regulator and bottle dealer’s
instructions.
Operation
Warnings
Before proceeding, make certain that you
understand the IMPORTANT
INFORMATION section of this manual.
Your barbecue is not designed to be used
with more than 50% of the cooking area as a
solid plate — this includes baking dishes.
Full coverage will cause excessive build-up
of heat and damage the barbecue. This is
not covered by warranty.
Preparation Before Cooking
To prevent foods from sticking to the cooking
surface, please use a long handled brush to
apply a light coat of cooking or vegetable oil
before each barbecuing session. (Note:
When cooking for the first time, paint colours
may change slightly as a result. This is normal
and should be expected.)
Line the drip tray with aluminium foil, then
place a uniform layer of clean, dry sand 6-8mm
deep into the tray. This will absorb excess
cooking fat, thus making cleanup easy.
Lighting the Barbecue
Open the barbecue and side burner hood or
lid before lighting. Never
light your barbecue
or side burner with the hood or lid closed.
Ensure all knobs are in the off position.
Open the gas control valve on the gas bottle
or regulator.
Push and turn the control knob of the
leftmost burner to the high position. Press
the ignition button rapidly several times until
burner is lit.
If burner fails to ignite after following above
procedure, turn all the knobs to the off
position. Close the gas valve on the gas
bottle. Wait 5 minutes. Reattempt all of the
above steps. If the barbecue still fails to
light, please refer to the manual ignition
instructions below.
After successful lighting of the leftmost
burner, ignite the remaining burners in
sequence from left to right. Confirm each
burner is alight before igniting another
burner.
After ignition, turn the burners to the high
position for 3-5 minutes in order to pre-heat
the barbecue. This should be done before
each cooking session. The hood or lid
should be open during preheating.
After completion of preheating, turn all
burners to the low position for best cooking
results.
Manual Ignition Instructions
Open the barbecue and side burner hood
or lid before lighting. Never
light your
barbecue or side burner with the hood or lid
closed.
Ensure all knobs are in the off position.
Open the gas control valve on the gas bottle
or regulator.
Insert lit match through the right match-
lighting hole on the right side of the
barbecue body and place near rightmost
To Next Page
Loading...
Need help?
General
