oventrop Multidis SF - Ball Valve; Heat Meter; Transport and Storage

Multidis SF
Transport and storage
4.1 Ball valve
When selecting the cabinet, please note
that the overall depth and length of the
Multidis SF heating circuit distributor/
collector will increase if you use
accessories such as ball valves or heat
meters.
Fig. 6: Dimensions of the ball valve
Item no. Size D L L
 DN  G¾  mm  mm
 DN  G  mm  mm

(with
thermo-
meter)
DN  G¾  mm  mm

(with
thermo-
meter)
DN  G¾  mm  mm

(with
thermo-
meter)
DN  G  mm  mm

(with
thermo-
meter)
DN  G  mm  mm
To obtain the length with the ball valve
attached, add the length of the Multidis
SF heating circuit distributor/collector
(L) to the length of the ball valve (L).
•
The ball valves item no.  and
 have a red T-handle which
shall mark the supply pipe.
•
The ball valves item no.  and
 have a blue T-handle which
shall mark the return pipe.
4.2 Heat meter
The installation of commercially available G1
and G¾ heat meters is possible.
The dimensions of the heat meter can
be obtained from the corresponding
operating instructions.
5. Transport and storage
Transport the product in its original packaging.
Store the product under the following
conditions:
Temperature range
-°C to +°C
Relative air
humidity
max. %
Particles
Store in a dry and dust-
protected place
Mechanical
influences
Protected from
mechanical shock
Radiation
Protected from UV-rays
and direct sunlight
Chemical
influences
Do not store together
with solvents,
chemicals, acids, fuels
or similar substances
23140655281-V01.07.2021