5
START-UP – ELECTRIC MOTOR
Before starting the engine, read the
manufactures motor installation and
maintenance manual.
Check the fluid levels of the hydraulic
reservoir.
Push the start button to engage the motor
Check motor rotation.
Check the power plant for leaks or other
problems.
You are now ready to run the lid up and down.
Raise the lid by pulling the valve handle
toward you.
Lower the lid by pushing the valve handle
away from you.
NOTE: Operate the crusher manually to get
familiar with it and to test its operation prior to
using the remote control.
Although the machine was tested at the factory
it is always a good idea to check for oil leaks.
COLD WEATHER STARTING: 1. Start electric motor and run for 5 – 10 minutes to help
circulate oil through pump. 2. Move lid up and down manually or with switches on transmitter
(hand-held) to help warm hydraulic oil. Note: Allow at least 30 minutes for steps 1 and 2.
MANUAL/AUTOMATIC SWITCH: Operating the crusher in the manual position deactivates
the 20-minute safety shutdown timer (for cold weather warm up) and the remote start/stop
function from the transmitter. When the crusher is operating, turn the switch to auto to activate
the 20-minute safety timer and the remote start/stop feature.
To Next Page
Loading...
