To Next Page

To Previous Page

Getting Started

2.1 Device Setup

This section describes the process of setting up the OWC Express 1M2 if purchased

with a pre-installed drive (NVMe SSD installed from factory).

1. Connect the included 0.3M (12") USB4 cable to the USB4 port on the back of the

OWC Express 1M2. Connect the other end of the cable into a compatible host.

Questions and Answers:

Need help?

Do you have a question about the OWC Express 1M2 and is the answer not in the manual?

OWC Express 1M2 Specifications

General