To Next Page

To Previous Page

2. The OWC Express 1M2 comes formatted as APFS for Mac systems. This allows for

a seamless plug-and-play experience between Mac and iPad systems. Connect the OWC

Express 1M2 to a Mac or iPad and immediately begin using the drive.

NOTE : Windows, ChromeOS, and Android users will need to reformat the Mac

formatted OWC device over that operating system to begin use. Please consult the support

article " OWC Drive Setup Over Non-Apple Platforms " for instructions regarding

reformatting the OWC Express 1M2 to work with Windows, ChromeOS, or Android

operating systems.

NOTE : Please consult the Support Manual for OWC Drive Guide or ##sDrive

Guide Support Guide page for additional information regarding OWC Drive Guide.

2.2 Assembly Steps

This section describes the process of installing a drive into the OWC Express 1M2.

Opening the OWC Express 1M2 if pre-built (NVMe SSD installed from factory) will

VOID the warranty. If you wish to remove or replace the NVMe SSD after the

expiration of the original warranty, you may do so at that time.

NOTE : Instructional video for installing a drive into the OWC Express

1M2

Opening the Enclosure

1. Place the OWC Express 1M2 upside down on a flat static free surface. Remove

the (2) exposed case screws, with the included driver, which will allow access to the

inside of the enclosure. The screws may already be removed and included in a

baggie with the enclosure.

Questions and Answers:

Need help?

Do you have a question about the OWC Express 1M2 and is the answer not in the manual?

OWC Express 1M2 Specifications

General