(2) Lift the tilt stand and loosen the screws with a suitable Phillips screwdriver and
remove the battery cover.
(3) Observe the battery polarity indicated inside the battery compartment, Insert the
batteries.
(4) Place the battery cover back in its original position and tighten the screws.
used for a long period.
Adjusting the Tilt Stand
Pull the tilt- stand outward to its maximum reach (about 85° to the meter body).
Power On
(1) To power ON the multimeter, turn the rotary switch to any other position except
.
(2) To power OFF the multimeter, turn the rotary switch to the
position.
Sleep Mode
The multimeter automatically enters the sleep mode if the rotary switch is not moved or
a key is not pressed for 15 minutes. (When the Bluetooth is activated, this function is
disabled.)
Pressing any key will turn the multimeter back to operation mode from the sleep mode.
One minute before auto power-off, the buzzer will sound “BeBeBeBeBe” five times to
warn. Before it is shut off, the buzzer will sound a long ”Beee” then shut off.
Note: In sleep mode, the multimeter will still consume a little power. If the multimeter is
not going to be used for a long period, the power should be turned off.
Backlight Control
(1) To view the display in low-light conditions, you can activate the LCD backlight by
pressing for more than 2 seconds.
(2) To turn off the backlight, press for more than 2 seconds.
The backlight will last for 10 seconds.
To Next Page
Loading...
Need help?
General
