6
Reset Button
• Reset. Press and hold the reset button for 5 seconds until the LED
indicator ashes 3 times quikly to restore the power clamp to default
factory settings (energy data will be cleared). And it will get into EZ
mode for 3 minutes.
Reset Button
LED indicator
The LED status gives the following information of the power clamp:
LED Status What it means
Green LED
Rapidly blink: EZ pair mode
Slowly blink: AP pair mode
Green LED solid on Device has connected with router.
No light Device can not connect with router.
• EZ pair mode (Default): Quick pair devices. You can set all devices to
this mode, and then add devices in batches on your phone.
• AP pair mode: If you would like to pair one specic device during
many devices. Please refer to FAQ1 to configure network in this
mode.
To Next Page
Loading...
