Owon SDS1022 - How to Save and Recall a Waveform

4.Advanced User Guidebook
29
By selecting Type in the right menu, you can save the waveforms, configures or screen
images.
When the Type is selected as Wave, the menu is shown as the following table:
Function Menu
Setting
Description
Function
Save
Display the save function menu
Type
Wave
Choose the saving type as wave.
Source
CH1
CH2
Math
All
Choose the waveform to be saved.
(Choose All
to save all the waveforms that
are turned on. You can save into the
current internal object address, or into USB
storage as a single file.)
Object
ON
OFF
The object Wave0 –Wave15 are listed in
the left menu, turn the M knob to choose
the object which the waveform is saved to
or recall from.
Recall or close the waveform stored in the
current object address.
When the show is
ON, if the current object address has been
used, the stored waveform will be shown,
the address number and relevant
information will be displayed at the top left
of the screen; if the address is empty, it
will prompt "None is saved".
Next Page
Enter next page
Close All
Close all the waveforms stored in the
object address.
File Format
BIN
TXT
CSV
For internal storage, only BIN can be
selected. For external storage, the format
can be BIN, TXT or CSV.
Save
Save the waveform of the source to the
selected address.
Storage
Internal
External
Save to internal storage or USB storage.
When External is selected, the file name is
editable. The BIN waveform file could be
open by OWON waveform analysis
software (on the supplied CD).
Prev Page
Enter previous page
When the Type is selected as Configure, the menu is shown as the following table:
Function Menu
Setting
Description
Function
Save
Display the save function menu
Type Configure Choose the saving type as configure.