Need help?Do you have a question about the Owon SDS1022 and is the answer not in the manual?
General| Brand | Owon |
|---|---|
| Model | SDS1022 |
| Category | Test Equipment |
| Language | English |
Defines warning and caution terms and symbols used in the manual.
Describes the front, rear, and control panel layout of the oscilloscope.
Explains the various elements and indicators displayed on the oscilloscope screen.
Guides users through initial checks for damage and proper setup of a new oscilloscope.
Provides steps for a basic functional check to verify normal operation of the instrument.
Details how to configure the probe's attenuation setting for accurate measurements.
Offers essential safety precautions for using oscilloscope probes to prevent electric shock.
Explains the self-calibration procedure for optimal accuracy, especially after temperature changes.
Introduces the controls and practices for adjusting the vertical settings of the oscilloscope.
Introduces the controls and practices for adjusting the horizontal time base and position.
Explains the trigger system controls and basic trigger types for stable waveform display.
Details how to configure vertical settings like coupling, inversion, and probe attenuation.
Explains how to perform mathematical operations (add, subtract, etc.) on waveforms.
Guides on using the Fast Fourier Transform function for frequency domain analysis.
Details how to adjust horizontal position, scale, and enter zoom mode.
Provides detailed instructions on setting up trigger types like Single and Alternate triggers.
Covers operating main function menus like Utility, Measure, Acquire, and Cursor.
Explains settings for sampling modes (Peak Detect, Average) and display persistence.
Guides on saving and recalling waveforms, configurations, and screen images.
Provides instructions for updating the oscilloscope's firmware via a USB memory device.
Details how to use automatic measurement functions for voltage and time parameters.
Explains how to use cursors for precise time and voltage measurements.
Describes the functions of key executive buttons like Autoset, Run/Stop, and Copy.
Outlines steps for installing software, connecting, and configuring the oscilloscope for PC communication.
Demonstrates measuring frequency and peak-to-peak voltage of a basic signal.
Shows how to calculate amplifier gain by measuring input and output signal amplitudes.
Guides on capturing non-periodic signals using trigger settings and auto-trigger.
Explains how to use Peak Detect and Average functions to analyze signal noise.
Demonstrates using X-Y mode to analyze phase difference between two signals.
Shows how to use video trigger to capture stable video signals.
Addresses common problems like no display, unstable waveforms, and incorrect amplitude readings.
Lists key acquisition parameters like bandwidth, sample rate, and input characteristics.
Details specifications for vertical resolution, sensitivity, and bandwidth.
Covers measurement parameters, trigger levels, and accuracy.
Includes display, power, environment, and mechanical specifications.
Lists the standard accessories included with the oscilloscope.
Provides guidelines for maintaining and cleaning the instrument and probes.
To Next Page
