Need help?Do you have a question about the Owon SDS7102 and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Display | 7-inch TFT LCD |
| Dimensions | 350 mm x 160 mm x 110 mm |
| Timebase Range | 5 ns/div to 50 s/div |
| Connectivity | USB host, USB device, LAN |
| Trigger Modes | Auto, Normal, Single |
| Interface | USB, LAN |
| Memory Depth | 10 Mpts |
| Record Length | 10 Mpts |
| Vertical Resolution | 8 bit |
| Display Resolution | 800 x 480 |
| Trigger Types | Edge, Pulse, Video, Alternative |
| Math Functions | +, -, FFT |
| Input Impedance | 1 MΩ |
| Power Supply | AC 100V-240V, 50/60Hz |
| Vertical Sensitivity | 2 mV/div to 10 V/div |
Defines terms like Warning, Note, Danger, Warning, Note used in the manual and on the product.
Explains symbols like High Voltage, Please Consult the Manual, Protective Ground End, etc.
Provides steps for a general inspection of the oscilloscope upon receipt.
Guides on performing a quick function inspection to verify normal operation.
Explains how to perform probe compensation for accurate measurements.
Details how to set the probe attenuation coefficient for accurate readings.
Provides instructions on using the oscilloscope probe safely to prevent hazards.
Explains how to perform auto-calibration for optimal measurement accuracy.
Details how to configure the vertical system settings of the oscilloscope.
Details how to configure the horizontal system settings of the oscilloscope.
Guides on using the Fast Fourier Transform (FFT) function for frequency analysis.
Guides on setting up the trigger system for accurate waveform capture.
Instructions on saving current settings or waveforms to internal memory or USB storage.
Lists key performance characteristics like bandwidth, acquisition, and input specs.
Lists trigger-related performance characteristics such as level range and accuracy.
To Next Page
