Owon SDS7102 - 8 Technical Specifications

8. Technical Specifications
User Manual of Smart Digital Storage Oscilloscope
82
8. Technical Specifications
Unless otherwise specified, the technical specifications applied are applicable to the
probe with the attenuation switch setting 10X and the SDS series digital oscilloscope.
Only if the oscilloscope fulfill the following two conditions at first, can these
specification standards be reached.
 This instrument should run for more than 30 minutes continuously under the
specified operating temperature.
 If the change range of the operating temperature is up to or exceeds 5 , open the ℃
system function menu and execute the “Auto-calibration” procedure (see “How to
Implement Auto-calibration
” on P16).
All specification standards can be fulfilled, except one(s) marked with the word
“Typical”.
Performance Characteristics Instruction
SDS6062 60MHz
SDS7102 100MHz
SDS8202 200MHz
Bandwidth
SDS9302 300MHz
Channel 2 + 1 (External)
Mode Normal, Peak detect, Averaging
SDS6062
500MS/s
(250MS/s for dual channels)
SDS7102
1GS/s
(500MS/s for dual channels)
SDS8202
2GS/s
(1GS/s for dual channels)
Acquisition
Sample rate
(real time)
SDS9302
3.2GS/s
(1.6GS/s for dual channels)
Input coupling DC, AC , Ground
Input impedance 1MΩ±2%，in parallel with 10pF±5pF
Probe attenuation
factor
1X，10X，100X，1000X
Max. input voltage 400V (PK-PK) （DC + AC PK-PK）
Bandwidth limit 20MHz, full bandwidth
Input
Channel isolation
50Hz: 100 : 1
10MHz: 40 : 1