Owon SDS7102 - Recording and Playback Waveforms

5. Advanced User Guidebook
Fig.5-35 Wave Saving
How to Record/Playback Waveforms
Wave Record function can record the input current wave. You can set the interval
between recorded frames in the range of 1ms~1000s.The max frame number reaches
1000,and you can get better analysis effect with playback and storage function.
Wave Record contains four modes: OFF , Record , Playback and Storage.
Record: To record wave according to the interval until it reaches the end frame set.
Record menu shows as follows:
Menu Setting Instruction
Mode
OFF
Record
Playback
Storage
Close wave record function
Set record menu
Set playback menu
Set storage menu
End frame
Turn the M knob to select the number of frames to
record (1～1000)
Record mode
FrameSet
Interval
Turn the M knob to select the interval between
recorded frames (1ms～1000s)
Refresh
ON
OFF
Refresh wave during recording
Stop refreshing
Operate
Play Begin to record
Stop Stop recording
Note:
Both of the waveforms of Channel 1 and Channel 2 will be recorded. If a Channel is
turned off while recording, the waveform of the channel is invalid in the playback
mode.
User Manual of Smart Digital Storage Oscilloscope
51