Need help?Do you have a question about the Owon SDS5032E(V and is the answer not in the manual?
General| Bandwidth | 30 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 250 MS/s |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Input Impedance | 1 MΩ |
| Trigger Modes | Edge, Pulse, Video |
| Interface | USB Device, USB Host |
Precautions to avoid injury and damage during operation.
Defines terms like Warning, Caution, Danger and relevant safety symbols.
Details the layout and components of the oscilloscope's front panel.
Details the function of buttons, knobs, and control areas on the front panel.
Guides through a quick functional test to verify instrument operation.
Steps for adjusting the probe to ensure accurate waveform measurements.
Explains how to set the probe's attenuation factor in the oscilloscope menu.
Provides essential safety guidelines for using the oscilloscope probes.
Describes the procedure for self-calibration to optimize accuracy.
Guides on using VERTICAL POSITION and VOLTS/DIV knobs for display.
Provides detailed instructions for configuring the vertical system settings.
Guides on matching probe attenuation settings with oscilloscope menu settings.
Explains the usage of VERTICAL POSITION and VOLTS/DIV knobs for display.
Provides detailed instructions for configuring the horizontal system settings.
Provides detailed instructions for configuring trigger settings.
Explains trigger controls, modes (Single, Edge, Video, Slope, Pulse).
Instructions on saving and recalling waveforms, settings, and screen images.
Details the self-calibration procedure for optimal accuracy.
Step-by-step guide on how to perform a Pass/Fail test.
Guides on performing automatic measurements of signal parameters.
Instructions on using cursors for voltage and time measurements.
Guides on using the Autoscale function for automatic signal setup.
To Next Page
