5. Advanced User Guidebook
Using the LAN port, the oscilloscope can be connected with a computer directly, or
through the router to connect. The network parameters can be set in the menu below.
Press the Utility button and turn the G knob to select the LAN Set to go to the
following menu.
Fig.5-46 LAN Set menu
The description of LAN Set menu is shown as the follows:
Function
Menu
Setting Description
IP
Press F1 button to switch between each byte, turn the G knob
to change value (0～255)
Port Turn the G knob to change value (0～4000)
Netgate
Press F3 button to switch between each byte, turn the G knob
to change value (0～255)
Phy addr
Press F4 button to switch between each byte, turn the G knob
to change value (0～FF)
Set
Net mask
Press F5 button to switch between each byte, turn the G knob
to change value (0～255)
Save set Save the current settings and prompt "reset to update the config"
How to connect with a computer directly:
(1) Connection. Plug in the LAN line to the LAN port in the right side panel of the
oscilloscope; plug the other end into the interface of the computer.
(2) Set the network parameters of the computer. Since the oscilloscope can not
support obtaining an IP address automatically, you should assign a static IP
address. Here we set the IP address to 192.168.1.71.
55
To Next Page
Loading...
