5. Advanced User Guidebook
Fig.5-53 Measure Menu
The "Automatic Measurements" menu is described as the following table:
Function Menu Setting Description
Type Press F1 ,show the measure types
CH1
Source
CH2
Select the source
Show all Show all the measures on the screen
Add
Add
Add the selected measure types (shown
at the left bottom, you could only add 8
types at most)
Remove all Remove all the measures
Type
Turn G knob, select the types need to be
deleted.
Remove
Remove Remove the chosen measure type
Measure
The measured values can be detected on each channel simultaneously. Only if the
waveform channel is in the ON state, the measurement can be performed. The
automatic measurement cannot be performed in the following situation: 1) On the
saved waveform. 2) On the mathematical waveform. 3) On the XY format. 4) On
the Scan format.
Measure the frequency, the peak-to-peak voltage of the Channel CH1 and the mean,
the RMS of the Channel CH2, following below steps:
1. Press the Measure button to show the automatic measurement function menu.
2. Press the H1 button to display the Add menu.
3. Press the F2 button and choose CH1 as the source.
4. Press the F1 button, the type items will display at the left of screen, and turn the
60
To Next Page
Loading...
