5. Advanced User Guidebook
Fig.5-35 Wave Saving
Tip:
Whatever the Type of save menu is set, you can save the waveform by just pressing
the Copy panel button in any user interface. If the Storage of the save menu is set as
"External", you should install the USB disk. Please refer to the contents below to
install the USB disk and name the file to be saved.
Save the current screen image:
The screen image can only be stored in USB disk, so you should connect a USB disk
with the instrument.
1. Install the USB disk: Insert the USB disk into the "1. USB Host port" of "Fig.
4-3 Right side panel". If an icon appears on the top right of the screen, the
USB disk is installed successfully. The supported format of the USB disk: FAT32
file system, cluster size cannot exceed 4K. Once the USB disk cannot be
recognized, you could format it into the supported format and try again.
2. After the USB disk is installed, press the Save panel button, the save menu is
displayed at the bottom of the screen.
3. Press the H1 button, the Type menu will display at the left of screen, turn the G
knob to choose Image for Type.
4. Press the H4 button, the input keyboard used to edit the file name will pop up.
The default name is current system date. Turn the G knob to choose the keys;
press the G knob to input the chosen key. The length of file name is up to 25
characters. Choose and press the Enter key of the keyboard to end the input and
store the file with the current name.
46
To Next Page
Loading...
