Owon SDS7102 - Trigger System Introduction

4. Junior User Guidebook
Fig. 4-13 Horizontal Control Zone
1. Use the horizontal “SEC/DIV” knob to change the horizontal time base setting
and observe the consequent status information change. Rotate the horizontal
“SEC/DIV” knob to change the horizontal time base, and it can be found that the
“Horizontal Time Base” display in the status bar changes accordingly. The
horizontal scanning speed steps from
5ns up to 100s in the sequence of 1-2-5 (SDS6062) or
2ns up to 100s in the sequence of 1-2-5 (SDS7102，SDS8202，SDS9302).
2. Use the “HORIZONTAL POSITION” knob to adjust the horizontal position of
the signal in the waveform window. The “HORIZONTAL POSITION” knob is
used to control the triggering displacement of the signal or for other special
applications. If it is applied to triggering the displacement, it can be observed that
the waveform moves horizontally with the knob when you rotate the
“HORIZONTAL POSITION” knob.
3. With the “HORIZ MENU” button, you can do the Window Setting and the
Window Expansion.
Introduction to the Trigger System
Shown as Fig.4-11, there are a knob and three buttons in the “TRIGGER
CONTROLS”. The following practices will direct you to be familiar with the setting
of the trigger system gradually.
User Manual of Smart Digital Storage Oscilloscope
18