Important Note:
This part comes pre assembled
WITHOUT thread lock. Follow
the instruction for final assembly
Chapter 11: Main Rotor Assembly
OXY0757-
Main Grip Bushing
TCEM2X18-
M2X18 Hex Cap Screw
OXY0055-
2X3.5X0.5 Washer
DFC Arm
Once you finish assembly, ensure the DFC
Arms can rotate without friction. If the DFC
Arms are assembled correctly, rotation
should be smooth and without friction. In
case of any friction, recheck each
component and re-assembly as necessary.
Lower and Upper
Swash Plate
OXY0020-M1.2x2
Special Screw
Center Ball
Important Note:
this part, for tuning reasions,
comes factory pre assembled,
it ready to use.
OXY0018-2x
11.5 Anti Rotation Pin
OXY0019 -
Swash Plate Ball
OXY0043 -
Linkage Ball
Important Note:
This part comes pre assembled WITHOUT
thread lock. Follow the instruction for final
assembly.
Swivel Ball Note:
The Swivel Ball is pre-assembled with a
precise fitting. When new, the Swash Plate
center ball will have a little friction. After a
few flights and “break-in” it will come smooth,
keeping the best precision without play.
page 25
Swash Plate Assembly
( Box 3/ Bag 18 )
loctite 243
loctite 243
loctite 243
To Next Page
Loading...
