Ozito DMC-1000 - INFLATING; INFLATING TYRES

5. INFLATING TYRES 4. INFLATING
1 Open the side
compartment and roll
out the air hose.
3 Attach the air hose
by screwing the
end of the hose in a
clockwise direction.
5 Uncrew the air hose
and tighten plastic
cap onto the tyre air
valve.
2 Connect the 12V
socket to a power
supply. The current
pressure rating of the
item you are inating
will now appear on
the digital display.
4 Once the pressure
has reached the
desired rating,
remove the air hose
and roll up into the
side compartment.
3 Press down the on/off switch
to inate the tyre to the
recomended pressure is
reached.
NOTE: The required pressure
should be written on the item.
1 Attach the required adator for
the job.
NOTE: See the following
pages to select the correct
adaptors.
2 Unscrew the cap on the tyre air
valve.
4 Follow steps 2 - 3 in section 3.
“Inating” to inate the tyre.
6 Place the adaptors and air
hose back into thier original
compartments. Disconnect the
12V socket.
B
A
R
P
S
I
B
A
R
P
S
I
IMPORTANT: BEFORE CONNECTING OR DISCONNECTING
ACCESSORIES, ALWAYS MAKE SURE THAT THE
COMPRESSOR IS OFF.
WARNING: AVOID INFLATING THE OBJECTS ABOVE
THE RECOMMENDED INFLATION PRESSURE. THIS MAY
LEAD TO DAMAGE AND/OR INJURIES.