7
Step 1
On the y close windows, awnings and doors,
release guy ropes and Posibrace™ Velcro™ points
that attach the y to the poles and unhook all base
hooks. You can now remove y from tent. Lay y at
on ground and fold y in half, third or quarters. The
width of the folded y should be the length of the
pole bag, as indicated in Figure 10.
Step 2
Unzip windows, then collapse the tent by
removing and disassembling the poles in the
reverse order of the assembly instructions. Place
the poles in the pole carry bag and tie shut.
Step 3
Remove pegs with a claw hammer or peg puller.
Do not remove pegs from the ground by pulling
on tent base as this may cause damage to the tent.
Step 4
Spread the tent out at with all loose fabric folded
within the edges of the tent base. Try to atten the
tent as much as possible.
Step 5
Fold the tent in half, third or quarters. The width of
the folded tent should be the length of the pole
bag, as indicated in Figure 10.
Step 6
Lay the folded y over the folded inner tent.
Beginning at the back portion of the Fly and inner
tent bundle roll forward rmly allowing trapped air
to escape. It may help to use the bag of tent poles
as a rolling pin ensuring the tent edges are kept
straight as you roll.
Step 7
Once the tent bundle is rolled up, tie straps around
it and place into tent carry bag with peg bag,
instruction booklet and other miscellaneous parts.
If the tent won’t t into carry bag, unroll and reroll
more tightly.
Disassembly Instructions
Figure 10
HELPFUL HINT
Never store your tent damp or dirty. If you
have no choice to return home from your
camping trip with a damp or dirty tent,
make sure you lay it out to air in a cool, dry
and shaded place as soon as possible and
only pack it away when it is completely dry
and clean.
To Next Page
Loading...
