PABX MS308 - 3.3 CO Line Management

8
3.3 Enable/Disable C.O. Lines
After you use program 0000# above you must use the following commands to enter the number of
actual BT (or other) C. O. lines connected to the PABX before using this product!
If you do not enable any C.O. lines, the system will think there are no lines – it will not auto-detect
the lines!
3.3.1 Enable All C.O. Lines
Format: 0600#
Description: Enable all C.O. lines
Default setting: All lines are disabled
3.3.2 Enable Specific C.O. Lines
Format: 060M#
Explanation: Where M = the C.O. line number (either 1, 2, 3 or 4)
Description: Enable a specific C.O. line
Example: You want to enable C.O. line 1 and C.O. line 2; line 3 is not in use
3.3.3 Disable All C.O. Lines
Format: 0610#
Description: Disable all C.O. lines
3.3.4 Disable Specific C.O. Lines
Format: 061M#
Explanation: Where M = the C.O. line number (either 1, 2, 3 or 4)
Description: Disable a specific C.O. line