PAC AP4-CH41 - AmpPRO App; Minimum Volume Level; Chime Volume Level; Front; Rear Chimes Enabled

PAC
®
| Ph. 866-931-8021 | support@pac-audio.com
©2016 Pacic Accessory Corporation
www.pac-audio.com
Rev. 121216
Page 4
Pacific Accessory Corporation
Amplier Integration Interface for
Chrysler / Dodge / Jeep / RAM
AP4-CH41
AmpPRO App
Use of the AmpPRO App allows
you to do the following:
• Congure User Interface Options such
as:
• Minimum Volume Level
• Chime Volume Level
• Enable / Disable AP4 Chimes
• Enable / Disable factory EQ
• Bass / Mid / Treble boost
frequencies and Q factor
• Update Product Firmware
• Read Firmware / Hardware Versions
PLEASE NOTE: These settings can be adjusted with the module installed in the vehicle, or on the bench. However, it is
recomended to make the adjustments with the module installed, and the factory radio on, so that the changes can be
heard.
Minimum Volume Level - This allows you to set the minimum volume level of the factory radio (factory radio volume level 1)
Chime Volume Level - This allows you to set the volume of the AP4 chimes (ie: park sensors).
Front / Rear Chimes Enabled - This allows you to enable/disable AP4 chimes (ie: park sensors). This is used when mixing
factory and aftermarket speakers.
3 Band EQ Enabled - This allows you to enable / disable the 3 band factory EQ.
Bass / Mid / Treble Freq / Q Factor - This allows you to set the center frequency that will be adjusted when setting the 3 band
factory EQ, as well as the Q Factor for each frequency. The Q Factor determines how many of the adjacent frequencies will be
affected when adjusting the selected frequency. The lower the Q Factor, the more frequencies will be affected.
60HZ 500HZ 7.5KHZ
80HZ 1KHZ 10KHZ
100HZ 1.5KHZ 12.5KHZ
120HZ 2.5KHZ 15KHZ
0.50 0.75
1.00 1.00
1.50 1.25
2.00 1.50
Bass Frequency Mid Frequency Treble Frequency
Available Frequencies and Q Factors
Bass Q Factor Mid Q Factor Treble Q Factor
0.75
1.25