Introduction
The MBT 250 systems are equipped with a Temperature Setback feature which, when enabled, will preserve tip life
and reduce energy consumption.
Procedure
ACTIVATION
There are two ways in which the system will enable the Temperature Setback feature.
1. AUTOMATIC OPERATION - The system memory can be programmed so that each Active Channel will
automatically and independently set back its Set Tip Temperature to 180°C (350°F) after a selected
period (10-90 minutes) of handpiece inactivity. See "Calibration" section for details on programming
this feature.
2. MANUAL OPERATION - The operator can manually force the system to place all Active Channels in
Temperature Setback by performing the following procedure.
a)
Press and hold the Scroll Down Key.
b)Press the Scroll Up Key.
c) Release both keys.
44
To Next Page
Loading...
