i
3. While holding the shoe against
the rim, tighten the shoe fixing nut.
\
5 mm Allen key
4. Pass the inner cable through the inner
cable lead. Set the cable with a clearance
of 1ram between each brake pad and the
rim, tighten the cable fixing bolt.
B+C=2mm
5 mm Allen key
ii ii iii
5, Adjust the balance with the spring
tension adjustment screws.
q)
Spring tension
adjustment screw
®
1 mm tmm
Spring tension
adjustment screw
6. Depress the brake lever about 10 times as
far as the grip and check that everything is
operating correctly and that the shoe clearance
is correct before using the brakes.
Depress about
10 times
" L
45 (_) Copyright 2000 Pacific Cycles
To Next Page
Loading...
