Pacific 110ACX - Output DC Offset; Output Protection; Output Control Characteristics; Mechanical Specifications

SECTION 2 SPECIFICATIONS
17
2.1.10 OUTPUT DC OFFSET
The DC offset present on the output is: < 20 mVDC.
2.1.11 OUTPUT PROTECTION
The output of the ACX Power Source is protected through the use of electronic current limiting.
The output will automatically recover when the output fault is removed. Thermal overload
protection is also provided. Refer to paragraph 2.3.5 for details.
The universal AC output socket that is located on the front of the ACX is limited to 10 A(RMS)
operation. It is protected by a 10A circuit breaker located at the rear of the power source. If the
current draw at the socket exceeds the 10A rating, the circuit breaker will disconnect power to
the socket. Reduce the load at the socket and press the circuit breaker button to reset.
NOTE: The digital controller also provides programmable current limit.
Refer to the UPC Series Operation Manual for details.
2.1.12 OUTPUT CONTROL CHARACTERISTICS
Output control characteristics, sync I/O signals, and metering capabilities are determined by the
controller which is installed. Refer to the UPC Series Operation Manual for details.
2.1.13 OUTPUT ISOLATION
The output of the ACX is galvanically isolated from the chassis and input power. Output Neutral
to Chassis voltage is allowed to be 150 VAC, maximum. See paragraph 3.4, Output Power
Connection, for grounding information.
2.2 MECHANICAL SPECIFICATIONS
The ACX Power Source mechanical characteristics are:
2.2.1 DIMENSIONS AND WEIGHT
Parameter Value Notes
Height:
3.5" / 89 mm
2U rack mountable units
Width:
19.00" / 483 mm
Front panel with mounting brackets
16.75" / 426 mm
Main chassis
Depth:
23.62" / 600 mm
Measured from back side of front panel, excludes
terminal blocks
Weight:
40 lbs. / 18.2 kg