Hold the cable near the machine inlet and form a straight loop;
approximately 15cm, as shown in the illustration.
Feed the cable through the slot until it passes the hook. Secure onto
the hook.
You may have to push the waistband buckle aside to allow the cable to
pass through.
Once the cable is secured onto the hook, pull the cable away from the
machine to ensure a tight fit, as shown in the illustration.
15
Installing the cable
1
2
3
Your machine comes fitted with the optional harness waistband. To
remove it if you prefer to not use it, hold the metal clip located at the end
of the waistband and pass through the slit at the back of the harness,
then through the elasticated slot on the side of the harness.
OPTIONAL HARNESS WAISTBAND
To install the optional harness waistband, take one piece and pass
through the elasticated slot on the side of the harness and feed the
metal clip through the slit at the back of the harness, securing into place.
Removing
waistband
Installing
waistband
ENGLISH
Velo
To Next Page
Loading...
