Push the cable forward to release the cord from the hook.
Once disengaged from the hook, pull the cable out by passing it
through the slot.
You may have to push the waistband buckle aside to allow the cable to
pass through.
Pull the cable until it is clear from the machine.
14
Operating Instructions
Removing the cable
1
2
3
1. Wear the machine comfortably, adjust the
harness if needed.
2. Stand upright, with the anti-static curved
handpiece section parallel to the floor.
3. Turn the machine on. The switch is located
underneath the machine.
4. Hold the anti-static curved handpiece with one
hand at a comfortable arm’s length.
5. Move forward and away from the power point.
6. Use easy underarm swinging motion when
detail cleaning and short dabs when spot
cleaning, always standing upright.
7. Once the end of the power cord has been
reached and work completed, return to the
powerpoint along the cord line to switch the
power off, and disconnect the power cord from
the powerpoint.
8. If work is not completed and you need to move
to another area, switch mains off, disconnect
the power cord, move toward desired area,
connect power cord to the nearest powerpoint
and repeat steps 1 through 6.
9. If work is completed disconnect power cord
from the power point and wind from the
machine towards the end of the power cord to
reduce likelihood of cable twists. In the process
check for nicks, cuts, fractures, and knots.
To Next Page
Loading...
