7
CONNECTING TO THE INT ERNET ( CONT INUED)
PPPoE:
To configure the router using a PPPoE connection, you will need to complete the
following steps:
A. Determine the following information provided by the ISP:
i. PPPoE username
ii. PPPoE password
B. Plug your PC into the router using an Ethernet cable.
C. Open any internet browser on the PC and go to http://192.168.1.99.
D. Log in to the router using pakedge / pakedgef as the username and password.
E. Navigate to System -> Network on the left-hand side of the screen and select
Interface.
F. Next, click on wan1. You should see its configuration page.
G. Click on the PPPoE radio button under the Addressing Mode heading.
H. Enter the username and password information provided by the ISP. Hit OK at the
bottom of the screen.
I. The router is now configured and ready for use. You can now access the internet.
To Next Page
Loading...
