Pakedge Device & Software WK-1-C - Page 4

6 7
3. Using the supplied template, cut a 9.125” diame-
ter circle at the desired mounting location for your
WK-1-C. Route an in-wall Ethernet cable through
the opening on the back of WK-1-C housing.
Insert the WK-1-C into the ceiling/wall.
4. Use a Phillips screwdriver to tighten the mounting ears. Use a clockwise rotation.
NOTE: Do not use excessive force when tightening the mounting-ears. This can strip the mounting
ears and render them non-functional.