Document #: 4100022 Revision: F Page #: 11 of 21
6. DOLLY - TANK ASSEMBLY
Note: Certain larger tanks (>350L) are constructed in two parts.
7.1. The Dolly has a pre-cut hole over the drive port. Insert the Interface into this hole
from below and apply the O-ring as shown (see Figure 2) to secure. It is not
necessary to remove or replace the Interface after mixing or between batches.
7.2 Position the plastic tank on the dolly. The bottom surface of the tank has two pre-
cut holes: a small hole for the bag drain and a larger hole for the drive head. Line
up the larger hole with the hole in the dolly over the drive port. The larger whole
should fit loosely around the Interface.
To Next Page
Loading...
