To Next PageTo Next PageWhy does my Paloma RAC-W25FR Heater not ignite?
If the Paloma heater does not ignite, it might be because the supply gas valve is not fully opened or there is air in the gas hose. Ensure the gas valve is fully opened to resolve this issue.
How to troubleshoot a Paloma Gas Heater that won't turn on?
If your Paloma Gas Heater doesn't operate and the ON/OFF light doesn't glow green, check the following: * Ensure the power cord is plugged in and the power is on. * See if a circuit breaker or fuse has blown. * Verify that the child lock is not set. * Confirm that the gas is turned on. * Make sure there is enough gas left in the LPG tank (if using an LPG appliance).
Why won't my Paloma Gas Heater ignite?
If your Paloma Gas Heater does not ignite and the ON/OFF light does not glow red, it may be because the supply gas valve is not fully opened or there is air in the gas hose.
Why does my Paloma RAC-W25FR smell like gas?
If you smell gas, it could be due to a hose that is not securely connected or is damaged. Ensure the hose is properly connected. If the issue persists, turn off the Paloma heater and call a qualified person.
Why does my Paloma Heater smell during use?
If the Paloma heater smells during use, it might be due to recent painting, waxing, or polishing in the room. Ventilate the room properly before use to resolve this issue.
What to do if my Paloma Gas Heater smells like gas?
If you smell gas when using your Paloma Gas Heater, it could be due to a hose that is not securely connected or a damaged hose. Turn off the heater and call a licensed plumber.
Why Paloma Room heater turns off during operation?
Your Paloma Room heater might be turning off during operation due to a clogged air filter, which will cause the filter lamp to flash; in this case, clean the air filter. Also, make sure that the hot air outlet is not blocked.
How to make my Paloma RAC-W25FR Heater heat the room better?
If the room is not becoming warm enough, the set temperature might be too low. Check if a window or door is opened. Ensure the supply gas valve is fully opened and that the room size suits the heater capacity. Also, make sure there is no obstruction within 75cm in front of the Paloma heater.
What to do if my Paloma RAC-W25FR turns off during operation?
If your Paloma heater turns off during operation, it could be due to a clogged air filter. Clean the air filter. Also, make sure that the hot air outlet is not blocked.
Why does my Paloma Gas Heater smell or smoke when using it for the first time?
The smell or smoke comes from oil used during manufacture. Operate the heater for a while in a ventilated room.
General| Model | RAC-W25FR |
|---|---|
| Category | Heater |
| Power Consumption | 2500W |
| Voltage | 220-240V |
| Frequency | 50Hz |
| Thermostat | Yes |
| Overheat Protection | Yes |
| Tip-over Protection | Yes |
Describes physical components of the heater, including front and rear views.
Details the functions and indicators on the heater's control panel.
Explains how to use the infrared remote controller for basic operations.
Lists advanced functionalities such as dual timers and economy operation.
Highlights built-in protective mechanisms like anti-tilt and overheat shutoff.
Compares specifications like heating capacity and gas input for different models.
Steps before installation, including gas type confirmation and room sizing.
Defines Danger, Warning, and Caution levels for hazardous situations.
Actions to take in case of a gas leak or fire.
Lists things not to do during operation and potential hazards.
Specific usage rules, including electrical safety and environmental considerations.
Details placement requirements, minimum clearances, and floor considerations.
Points to check regularly and instructions for cleaning the heater.
Steps for cleaning air filters and recommendations for professional servicing.
Step-by-step instructions for turning the heater on and off.
Explains the automatic economy mode and how to adjust room temperature settings.
How to manually override timers and use the remote for basic functions.
Step-by-step guide for setting and changing the heater's clock.
Instructions for setting the ON and OFF times for Timer 1.
Instructions for setting the ON and OFF times for Timer 2.
Explains the automatic pre-heat function that warms the room before timer start.
Step-by-step guide for activating and using programmed timers.
How to cancel programmed timers and activate/deactivate child lock.
Table listing common heater problems and suggested remedies.
Explains error codes displayed by the heater and their solutions.
Covers warranty scope, conditions, and what is not covered.
Details warranty coverage for parts, modifications, and claim conditions.
How to make a warranty claim and consumer law rights.
Information for contacting Rheem service for repairs and spare parts.
Details the certification number from the Australian Gas Association.
