Panasonic AG-7330 - Page 37

AUDIO DUBBING
Your
own
soundtrack
may
be
substituted
onto
a
previously
recorded
tape
by
using
either
a
microphone,
or
the
output
of
a
tape
recorder.
This
unit
can
be
made
to
dub
on
audio
channel
1
or
channel
2
separately,
and
if
connected
to
CH1
and
CH2
at
the
same
time, sound can be recorded on the audio tracks CH1 and CH2.
Connections
Audio Cable(s)
Tape Recorder
Connection with Microphones
Audio Input Connector
Vi (CH1 and/or CH2)
AG-7330
TV Monitor
Microphones
If
the
microphone
and
audio
cables
are
connected
at
the
same
time,
only
microphone
sound
will
be
recorded.
Switch Settings
eSet input Signal Selector to “LINE”.
eTur the VTR “ON”,
*lnsert a cassette. Make sure that the tab is in place.
Turn the TV Monitor “ON” and select the same channel as
the VTR (unused broadcasting channel).
Set the EXT Timer Selector to “OFF”.
eSet the Audio Dubbing Selector to the desired position.
CHI! : When dubbing audio CH1 only.
CHI/CH2 :When dubbing audio mixed CH1 and CH2
audio.
CH2 :When dubbing audio CH2 only.
Clear the Tape Memory.
1) Locate the tape segment where you wish to start audio
dubbing by using the JOG/SHTL Dial.
2) Turn the JOG/SHTL Dial to the Still Mode.
3) Press the Audio Dub and Play Buttons at the same time.
The audio dubbing will start.
When Searching for the Segment to be
Dubbed
Make the search speed constant.
Press the Pause/Still Button to activate the Still Mode.
When advancing a little more...
Release Still mode by pressing the Pause/Still Button once
again.
Repeat steps 1~3 until the desired segment is located.
on >
—37=