Panasonic AG-7330 - Page 38

TIME CODE
In order to record the EBU TIME CODE signal, connect the EBU time code generator to the Time Code Input Jack during recording,
and select “TIME CODE” on the Audio CH2 Selector. Then time code signal will be recorded on audio CH2 track.
Connections
Note:
The counter display on the VTR does not count the time code
signal. It counts the contro! (CTL) signal recorded on the tape.
Therefore connect the Time Code Reader in order to read the
time code.
TIME CODE GENERATOR
TIME CODE READER
Operations
1) Set the Audio CH2 Selector to “TIME CODE”, by 3) When the Time Code Signal is connected, Audio CH2
ON-SCREEN mode. Meter indicates 0.
AUDIO LIMITER OFF
DOLBY NR vom 4 a
AUDIO CH2 “4 TIME CODE |>
TAPE SELECT NORMA
TAPE IN MODE STOP ou *
TAPEENDMODE STOP
AUTOBACKSPACE OFF
FRAMING OFF
OIRECT SEARCH OFF
REMOTE PIN CAMERA
Time code signals may be recorded during the normal
recording or dubbing (including audio dubbing) modes. For
details, refer to the Operating Instructions of your time code
generator/reader.
2) Set the CH2 Meter Selector to the “CH2” position.
CH2 METER
TRACKING
AUDIO
CH2