Panasonic AG-7330 - Page 40

Audio Monitor Output Channel Selector
This is to select the audio channel 1, channel 2 or both
channels for monitoring through Audio Monitor Output jack.
The audio monitoring level can be adjusted on the TV Monitor.
When monitoring through the headphone connector, see page
17.
Note: :
When the Audio CH2 Selector (ON-SCREEN mode) is set to
“TIME CODE", set this switch to ““CH1”. (When the switch is
set to “MIX” or “CH2”, recorded time codes can be heard.)
TIME CODE ‘AUDIO OUT
cH cH
NORM/Hi-Fi ca)
O- O-
AUDIO
MONITOR
I
Setting of Audio Monitor
Output Channel Selector
CH1 Audio from channel 1 only
MIX Sound from both channels is
mixed
Note:
When using the Audio Output Jacks CH1/CH2, audio signals
are not affected by the Audio Monitor Output Channel Selector
setting.
Audio Monitor Output Jack
a a ee
S-VHS Selector
Normally use this selector in the “ON” position.
eWhen desired to record the S-VHS tape in the VHS mode,
set the S-VHS Selector to the OFF position.
Table described below is the recording reference between
the S-VHS Selector and the tape.
ON
Vertical Lock Adjustment
elf picture jitters vertically in STILL, adjust the V-Lock Control,
but a one time adjustment should be necessary.
If monitor TV Set has a vertical hold control, adjust this
together with the V-Lock Control.
FRONT
° 1°)
(Bottom view of AG-7330)
V-LOCK
PAL CCIR
NTSC 4.43
Smail driver