Panasonic AG-8700E - Page 48

L<Seiie] Oa
COGOOO Fe
ogee |faFagg
Setting the CTL/TC/UB button
This selects the time code mode which is indicated on the CTUTCIUB
display.
CTL: The CTL (control) signal value is indicated. C_)
TC: The time code value is indicated.
UB: The user's bit value is indicated.
Setting the LTC/AUTO/VITC button
This selects the read out mode of the time code.
LTC: The LTC time code signal recorded on linear track CH2
is read out. LTC/AUTO/VITC
AUTO: AUTO: Priority is given to reading out the VITC signal =]
when in the slow mode, and to reading out the LTC
signal at all other times.
VITC: —VITC: Only the VITC signal is read out.
¢ Interpolation is provided by the CTL signal when it is no
longer possible to read out the time code signal in any of the
modes.
Settings with the dial menu functions
The time code set-up can be performed using dial menu function
item No. 7001 to 7009. (See page E-45, E-46.)
The preset values for the time code and user’s bit can be set
using dial menu function item No. 7010 and 7011.
— E-48 —